Global Polytec Ltd.,Part.

Posts Tagged ‘going’

Question by William G: What is the going rate of an injection molding set-up operater?
I am looking for a job in the plastic industary. I was wondering what the average hourly rate is.

Best answer:

Answer by Mr Soul
unless you have training of some sort or experience you’ll probably have to start in maint. or operations.

wages depend on geographic area.

What do you think? Answer below!

Question by wbski: how do you know when a diesel injection pump is going bad?
acts like its running out of fuel,but its not ,its getting plenty,lots of air bubbles in the return line when it starts acting up.I’ve had so much trouble that I used clear plastic lines so I could see whats going on.could it be the injection pump?sometimes it runs fine for days and then bingo its back.

Best answer:

Answer by busnuttwo
you have air geting into fuel system from where ? you did not not list car or engine so hard to help more but air in return to tank means air is comming some where

Add your own answer in the comments!

Question by hacker: 92 festiva oil coming up on motor and oil in the plastic going from the breather to the fuel injection port?
I had a new timing belt put on prior to this but has never had any power since. I had the engine totally overhauled about a year ago and it ran fine but since I replaced the timingbelt it hasn’t ran right sence. there is no power at all. I replaced the PCV valve but still get oil back in the breather area from breather to fuel injector.The engine shuts off real fast like its to tight and there is oil that drips on the floor, uses about a half quart every 30 or 40 miles.There is blue smoke that comes out periodically but not all the time.There is a small water leak on the floor, could this be from the water pump leaking on the timing belt ,and cause the timing belt to jump time.Sometime it is hard to start when you turn it off so I let run to get back home. Have put new plugs and coil wire in it. What could be my problem. THANKS

Best answer:

Answer by Jcontrols
Do a compression check.Sounds like excessive blow-by in one of the cylinders,,;-(=

Know better? Leave your own answer in the comments!